Yet Remote Control Manufactory specialized in wireless remote control with 19 years of experience.
Language
Yet Remote Control Manufactory specialized in wireless remote control with 19 years of experience.
YET870-V2.0 is a AC24 voltage swing arm door controller that can drive dual motors.The controller has many interfaces and strong applicability.The main applications of the product are swing-arm door opener and in-ground swing door opener.
Product features:
· The product has a digital tube display,which is convenient for function and parameter configuration
· Two-relay 24V DC motor interface(requires motor with feedback signal output)
· External manual switch interface
· Two-way infrared sensor signal input interface
· Electromagnetic lock interface(12v/24v)
· Flashing light interface(24V DC)
· Back storage battery input interface(24V DC)
· Functions:Automatic door closing ,Door opening delay,Door closing delay,Rebound strength setting,Single and dual door selection,Electric lock setting,Model selection,Working mode setting of external manual control,Flashing light pre-flashing,External IR2 infrared working mode selector,Operating speed selection,Soft stop speed selection,Activate the force setting,Return to factory defaults
The method and steps of learning and clearing the code
Learning
Dual Door Control Learning
Long press the "C" button on the controller (more than 2 seconds) until the tens and ones decimal points of the digital tube light up at the same time then release the button; at this time, press any key on the remote control until the decimal point in both the tens and the ones of the digital tube goes out at the same time, indicating that the learning is successful.
Single Door Control Learning
Long press the "C" key on the controller (more than 2 seconds),release the key until the decimal point of the tens and ones of the digital tube light up at the same time, then short press the "C" key, The decimal point of the ten digit of the digital tube goes out.At this point, press any key on the remote control until the decimal point of ones digital of the digital tube is off, indicating that the learning is successful.
Operation sequence description:
Long press the "C" key on the controller (more than 8 seconds), until the decimal point of tens and ones digits of the digital tube are on, then off, the controller will automatically clear the contents of the memory. To reuse, just learn it again.
